Concrete Steps Calculator

Enter your steps — risers, treads, width and platform — and get the concrete volume in cubic feet and yards (or m³), the volume with waste, a ready-mix order rounded up to the quarter yard and how many 40, 60 or 80 lb bags to buy. A second mode does the same for a suspended stair with a waist slab and landing.

By the Stair-Math TeamUpdated How we check this calculator

What are you pouring?

Your steps

risers

Steps up to the platform, counting the one onto the platform.

in

in

in

in

0 = no platform: the top step is one tread deep.

Quick picks:

Units

Your concrete

Section through the concrete steps to scale
Section to scale. Drag the end of the platform (or the landing) to change its depth.

Concrete notes

    Solved with your numbers

      Assumptions: solid steps are filled solid with concrete (no rubble or void fill); risers are vertical; the waist is measured square to the sloping underside; nosings are not deducted; the gravel base, footings and formwork are not included. Bag yields: 40 lb ≈ 0.30 ft³, 60 lb ≈ 0.45 ft³, 80 lb ≈ 0.60 ft³.

      Volumes are worked out from the step geometry on this page, and bag yields are the published yields of premixed concrete, listed under Sources. Tested against 5 worked cases, including a metric stoop and a suspended stair with and without a landing. See the method · Sources

      How to calculate concrete for steps

      Solid steps on grade are a stack of blocks. With n risers of height R, treads of depth T, width W and a top platform of depth P (one tread if there is no platform):

      volume = W × [Σ (i × R × T) for i = 1 … n − 1 + n × R × P]

      A suspended stair is a sloping slab with triangles on top. With waist thickness w and an optional landing slab of length L and thickness d:

      triangles = (n − 1) × R × T ÷ 2 · waist length = (n − 1) × √(R² + T²)

      volume = (triangles + waist length × w) × W + L × d × W

      ft³ = in³ ÷ 1728 · yd³ = ft³ ÷ 27 · with waste = × (1 + waste %)

      ready-mix = ceil(yd³ with waste × 4) ÷ 4 · bags = ceil(ft³ with waste ÷ yield)

      Worked examples

      Four steps and a platform

      1. Inputs4 risers of 7 in · 11 in treads · 44 in wide · 36 in platform · 10% waste.
      2. Steps(1 + 2 + 3) × 7 × 11 = 462 in² of step blocks; platform 4 × 7 × 36 = 1008 in².
      3. Volume1470 × 44 = 64,680 in³ = 37.43 ft³ = 1.386 yd³; 1.525 yd³ with waste.
      4. Order1.75 yd³ of ready-mix, or 69 × 80 lb, 92 × 60 lb or 138 × 40 lb bags.

      A suspended stair

      15 risers of 7.2 in on 10½ in treads, 36 in wide with a 5 in waist: triangles 529.2 in², waist 178.24 in long, 29.59 ft³ (1.096 yd³). Add a 36 in landing 5 in thick and it rises to 33.34 ft³ — order 1.50 yd³.

      How much concrete for steps?

      Solid steps 48 in wide, 7 in risers, 11 in treads — volume and 80 lb bags with 10% waste
      StepsNo platform36 in platform48 in platform
      20.24 yd³ · 12 bags0.60 yd³ · 30 bags0.77 yd³ · 39 bags
      30.48 yd³ · 24 bags1.02 yd³ · 51 bags1.27 yd³ · 64 bags
      40.79 yd³ · 40 bags1.51 yd³ · 75 bags1.86 yd³ · 92 bags
      51.19 yd³ · 59 bags2.09 yd³ · 104 bags2.52 yd³ · 125 bags

      The platform is often half the concrete — check its depth carefully. The table under your result shows your steps with different platform depths.

      Bags or ready-mix?

      Premixed bags yield about 0.30 ft³ (40 lb), 0.45 ft³ (60 lb) and 0.60 ft³ (80 lb). Mixing by hand is practical up to about half a yard; above about 1 yd³ you need 70 or more 80 lb bags, and the first concrete will be setting before the last is placed. Order ready-mix in quarter-yard steps — the calculator rounds the volume with waste up for you — and ask about short-load charges for small orders.

      Suspended concrete stairs

      A suspended stair spans between floors or landings like a sloping slab. Its volume is the step triangles plus the waist — the slab under the steps, measured square to the sloping soffit — plus any landing slab. It is a structural element: the waist thickness, reinforcement and bearing must come from an engineer’s design. The calculator gives the volume to order.

      Base, rebar and forms

      • Base: 4–6 in of compacted gravel under solid steps; footings to frost depth where required.
      • Reinforcement: bars or mesh in solid steps to control cracking; designed reinforcement in suspended stairs.
      • Forms: riser boards braced to the side forms, with each riser the same height — within 3/8 in, as for any stair.
      • Layout: set the risers and treads first with the stair calculator, and on sloping ground find the rise with the total rise calculator.

      What this calculator does not cover

      • Formwork, rebar quantities and gravel for the base.
      • Structural design of suspended stairs.
      • Cost: use the staircase cost calculator.

      Concrete steps FAQs

      How much concrete do I need for steps?

      Add up the blocks: each step is a block as wide as the stair, one riser high and as deep as everything in front of it, and the platform is the top block. Four 7 in steps with 11 in treads, 44 in wide, with a 36 in platform take 37.43 ft³ — about 1.4 yd³, or 1.5 yd³ with 10% waste.

      How many bags of concrete for 3 or 4 steps?

      Three 7 in steps 48 in wide with no platform take about 0.6 yd³ — about 30 × 80 lb bags with waste. Four steps with a 36 in platform take about 1.5 yd³ — around 75 × 80 lb bags, at which point ready-mix is easier.

      How do you calculate the volume of a concrete stair?

      For solid steps, multiply the width by the sum of each step block (step number × riser × tread) plus the platform (risers × riser × platform depth). For a suspended stair, add the step triangles (treads × riser × tread ÷ 2) to the waist slab (sloped length × waist thickness) and multiply by the width.

      Should I use ready-mix or bags for steps?

      Bags suit up to about half a yard. Above about 1 yd³ you would be mixing 70 or more 80 lb bags, and the pour would cure unevenly — order ready-mix. Ready-mix is sold in quarter-yard steps; the calculator rounds up.

      Do concrete steps need rebar?

      Solid steps on grade are usually reinforced with a few bars or mesh tied to the foundation to stop cracking and settlement. A suspended stair is a structural slab and must be reinforced to an engineer’s design — the calculator gives only the volume.

      How thick should a concrete stair waist be?

      The engineer sets it from the span and loads; 5–6 in (125–150 mm) is common for house stairs between floors. The comparison table under your result shows how the volume changes with the waist.

      Do concrete steps need a gravel base?

      Yes. Pour solid steps on 4–6 in of compacted gravel, with footings to local frost depth where the code requires them. The base is not part of the concrete volume.

      Sources

      1. Premixed concrete bag yieldsManufacturer-published yields for premixed concrete: 80 lb ≈ 0.60 ft³, 60 lb ≈ 0.45 ft³, 40 lb ≈ 0.30 ft³. Check the yield printed on the bag you buy.
      2. Unit conversions1 yd³ = 27 ft³ = 46,656 in³; 1 m³ = 35.3147 ft³.
      3. Waste allowanceCommon practice: 5–10% for spillage, uneven subgrade and form bulging.
      4. Concrete step geometryDerived from geometry: solid steps as stacked blocks; suspended stairs as step triangles plus a waist slab of sloped length × thickness.

      Code text is the final word. Editions and local amendments differ — check the edition your building department enforces.

      Stair materials & cost calculatorsAll 6 tools for what a stair takes to build or finish — lumber, concrete, carpet, flooring, paint and cost.View all 6

      Other stair calculator categories